Your shopping cart is empty.
Where to use Safe Passivator Liquid 630?
Safe Passivator Liquid 630 is recommended for:
Passivation after pickling: Applied to freshly pickled stainless-steel surfaces to promote restoration of the protective passive layer.
Passivation after mechanical treatment: Suitable after grinding, brushing, polishing, blasting and fabrication operations that may disturb the stainless-steel passive surface.
Free iron / smut removal: Helps remove traces of free iron and surface residues that may otherwise cause rust spots or discoloration.
Flash rust prevention: Particularly useful immediately after pickling where flash rust or brown staining may occur during drying.
Post-pickling treatment: Can be used as a final conditioning treatment before equipment is returned to service.
How to make safety as a priority while using Passivation Liquids - Use RXSOL Safe Passivator Liquid 630!
| Step | Procedure |
|---|---|
| 1. Surface Preparation | Ensure the stainless-steel surface is free from heavy grease, oil and loose contamination. Where required, pre-clean with a suitable alkaline or neutral degreaser. |
| 2. After Pickling | Thoroughly rinse away the pickling chemical with clean water before applying Safe Passivator Liquid 630. |
| 3. Application | Apply uniformly by low-pressure spray, brush, immersion or circulation depending upon the equipment and surface geometry. |
| 4. Contact Time | Allow approximately 10-15 minutes contact time under normal conditions. Do not allow the product to dry completely on the surface. |
| 5. Final Rinsing | Rinse thoroughly with clean fresh water. High-pressure rinsing may be used where appropriate. |
| 6. Drying | Allow the treated stainless-steel surface to drain and dry naturally or use clean, oil-free compressed air where required. |
Where smut or light flash rust appears immediately after pickling, apply Safe Passivator Liquid 630 while the stainless-steel surface is still wet.
Allow approximately 10-15 minutes reaction time and then rinse thoroughly with clean water.
For heavier contamination, pre-clean the affected surface, rinse with water and then apply Safe Passivator Liquid 630 to the clean, wet surface.
Where nitric-acid-containing pickling products are being used, Safe Passivator Liquid 630 may be applied as a fine mist over the wet treated surface as part of the post-pickling procedure to help suppress residual fuming.
This application should not be considered a substitute for proper ventilation, extraction or required PPE.
Why is RXSOL Safe Passivator Liquid 630 better than industry standard acidic passivation liquids?
Facing problems of toxic nitric acid fumes during pickling of metal? Prevent such hazardous fuming by using Safe Passivator Liquid 630 by RXSOL. This does not mean that no PPE should be worn or there should be no proper ventillation during pickling.
Prevent water staining caused by poor rinse water using Safe Passivator Liquid 630 by RXSOL.
Avesta FinishOne Passivator 630, Acid Free Passivation Liquid
Muscat, Salalah, Sohar, Duqm, Rustaq, Barka, Sanaiya, Sur, Seeb, Shinas, Nizwa, Oman, Bahrain, Abu Dhabi, Ajman, Al Ain, Dubai, Ras Al-Khaimah, Fujairah, Sharjah, Umm Al Quwain, Ruwais, Khalifa Port, Jebel Ali, DP WORLD, and all UAE ports...